Rokonet ORBiT-14 Manual do Utilizador descarregar pdf (Página 61)

Installation and Programming Manual

ZONES: MAINTENANCE (cont’d)

Quick Key Item Explanation

2 9 7 Zone Self Test

(cont’d)

i) and press [ENTER]

ii) at this display, press [8]

iii) and press [ENTER] again

iv) at this display, select the manner in which the UO will operate;

typically, by choosing PULSE N/O, the UO, acting like a

normally-open switch, will close for a predetermined period,

completing a circuit which can activate a noise source;

press [ENTER]

v) at this display, you may accept or rename the output if you

choose, and press [ENTER]

vi) finally, press [ENTER]; press the [TT] key, as required

UO=02 FOLLOWS:

1)SYSTEM ××

PATTERN UO=01:

2)PULSE N/O ↑↑

SYS.EVENT: UO=02

1)BELL FOLLOW ↓↓

SYS.EVENT: UO=02

8)SENSORS TEST ↑↑

LABEL FOR UO=02

OUTPUT 02

INSTALLER PROG:

2)ZONES ↓↓

1 2 ... 56 57 58 59 60 61 62 63 64 65 66 ... 69 70

Sem comentários

Rokonet ORBiT-14 Manual do Utilizador Página 61